Sony KDL-26M4000 - Manual (Page 7)

7
Gettin
g
Starte
d
2
Secure the TV to the stand.
Use the optional hardware listed below (not
supplied):
• M6 × 12-18 mm anchor bolt (screwed into the
TV’s Table-Top stand)
• A screw or similar (attach it to the TV stand)
• Rope or chain (strong enough to support the
weight of the TV). Make sure that there is no
excess slack in the rope or chain.
An alternative way to secure the TV is with an
optional Sony Support Belt Kit.
~
Contact Sony Customer Support to obtain the optional
Support Belt Kit by providing your TV model name.
• For United States call: 1-800-488-7669 or visit:
www.sony.com/accessories
• For Canada call: 1-877-899-7669
3 Anchor the TV to the Wall.
Use the hardware listed below (not supplied):
• Two M6 × 12-18 mm anchor bolts (screw into
the top-most wall-mount holes located on the
rear of the TV)
• Rope or chain (attach to one M6 anchor bolt)
• Wall-anchor (attach to the wall stud) strong
enough to support the weight of the TV (pass
the rope through the wall-anchor, then attach to
the other M6 anchor bolt).
~
• Measure 2 provides minimal protection against the TV
toppling over. For further protection, follow all three
measures recommended above. Anchor bolt
Screw
Screw hole on
the Table-Top
stand
Rope or
chain
Anchor bolts
Wall-mount
holes
Wall-
anchor
(Continued)