beautypg.com

American Standard 2076 User Manual

Page 3

background image

7 3 0 5 2 9 - 1 0 0 R e v . M

- 3 -

5

POSITION TOILET ON FLANGE
a.

Unplug floor waste opening and install toilet

on closet flange so bolts project through

mounting

holes.

b.

Loosely install retainer washers and nuts.

Side of washers marked "THIS SIDE UP"

must

face up!

CLOSET

BOLT

NUT

TAPERED
WASHER

FLANGE

6

INSTALL TOILET

a. Position toilet squarely to wall and, with a rocking motion,

press bowl down fully on wax ring and flange. Alternately
tighten nuts until toilet is firmly seated on floor.

CAUTION:

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b. Install caps on washers.

(If necessary, cut bolt height to size before installing caps.)

c. Smooth off the bead of sealant around base.

Remove excess sealant.

!

CLOSET BOLT

NUT

WASHER

BOLT CAP

9a

Before continuing, determine the type of water supply connection you have from the chart below and use the appropriate assembly parts
required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.

CAUTION: Overtightening of
LOCK NUT or COUPLING NUT
could result in breakage and
potential flooding.

These parts must be used as
illustrated to insure water-tight
connection. Use of existing
coupling nut may result in
water leakage. Water supply
tube or pipe must extend at
least 1/2" inside threaded
shank of valve (does not apply
to flanged tubing).

Use existing
coupling nut
and washer.

Use existing spiral
cone washer.
Fluidmaster cone
washer may not
seal completely on
spiral type supply
line.

Captive cone
washers already
included. No
additional washers
needed.

METAL/COPPER

FLARED TUBING

METAL FLANGED

TUBING

METAL SPIRAL

TUBING

VINYL/BRAIDED

CONNECTOR

LOCK NUT

LOCK NUT

LOCK NUT

LOCK NUT

COUPLING
NUT

COUPLING
NUT

EXISTING
COUPLING
NUT

COUPLING
NUT

WATER
SHUT-OFF

WATER
SHUT-OFF

WATER
SHUT-OFF

WATER
SHUT-OFF

CONE
WASHER

EXISTING
CONE
WASHER

EXISTING
WASHER

MANIFOLD INSIDE WATERWAY -
DO NOT REMOVE

INSTALL TANK

a.

Install large rubber gasket over threaded outlet on bottom of tank and lower tank

onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening,
and tank mounting bolts go through mounting holes. Secure with metal
washer/nuts.

b.

With tank parallel to wall, alternately tighten hex nuts until tank is snugged down

evenly against bowl surface.

Recommended tool: Deep socket tool included in tank kit.

!

CAUTION:

7

8

INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
DO NOT SPIN BOLTS WITH SCREWDRIVER

RUBBER
GASKET

TANK MTG.
BOLTS PRE-
INSTALLED

WASHER/NUT

CLOSET FLANGE