AccuTemp Steam N Hold - Manual (Page 9)

STEAM’N’HOLD™ MP4002-1103 9 of 17
on the brackets. Then, using a 7/16” wrench,
fasten one pair of the ¼”-20 hex bolts and ¼”
split lock washers through the underside of each
stand bracket mounting hole into the appliance
and tighten securely. Once the “bottom unit” has
been installed, carefully lift and place the “top
unit” on the top horizontal mounting brackets,
ensuring that the (4) mounting holes on the
underside of the appliance are lined up with the
mounting holes on the brackets. Then, using a
7/16” wrench, fasten one pair of the ¼”-20 hex
bolts and ¼” split lock washers through the
underside of each stand bracket mounting hole
and tighten securely. With the SNH20 stand,
level the appliance by adjusting the feet found
at the ends of each stand leg, either up or down
as needed.
WARNING!
When using a stand that is equipped with casters,
the floor surface must be level and flat. Failure
to do so can result in a “tipping” situation that
could result in serious injury.
INSTALLATION-CONT.
ELECTRICAL SuPPLy
The AccuTemp STEAM’N’HOLD™ appliance
has been designed, manufactured and tested to
meet or exceed the Underwriters Laboratories
safety standards. To ensure safety is maintained in
your installation, it is important that the following
paragraphs are understood before attempting
to apply power to your STEAM’N’HOLD™. If
there is any doubt as to whether your supply
receptacle is of the correct voltage, amperage,
or is properly grounded, consult a qualified
electrician or authorized service agent.
POWER REQuIREmENTS
AC power requirements are listed on the data plate located
on the left side access panel of
the appliance. This
appliance should never be connected to a circuit
operating at more than 150 VAC to ground and
should always be connected to an individual
branch circuit. Make sure the voltage at the
supply receptacle is within ±10% of the voltage
listed on the appliance data plate. Connection
to any other voltage may permanently damage
your STEAM’N’HOLD™ or cause premature
component failure. Damage of this type is
not covered under the product warranty. Each
appliance comes equipped with a connected 6
foot power cord and plug, rated for the power
requirements of each appliance. Damage caused
by removal or modification of factory standard
plug is not covered by product warranty.
GROuNDING
To reduce the risk of serious shock or death in the
event of an electrical short circuit, this appliance
must be grounded. The STEAM’N’HOLD™
is equipped with a cord having a grounding
wire and plug, which must be plugged into
a receptacle that is properly installed and
grounded. Under no circumstance should the
grounding plug be cut or bent to fit a receptacle
other than the one specified.
WATER SuPPLy-CONNECTED
Installation Requirements:
The Installer/Owner is responsible for the water
connection of this appliance.
This appliance is to be installed to comply with
all applicable federal, state, or local plumbing
codes.
The United Laboratories Sanitation (UL)
requires installation of a check-valve (or other
approved anti-backflow / anti-siphon device)
(not provided) in all supply lines in accordance
with and as required by local, state, and national
health, sanitation, and plumbing codes.
NOTE:
SCHEmATIC LOCATED INSIDE THE
CONTROL PANEL (LEFT SIDE)