Kinivo BTC8 Bluetooth FM Transmitter - Manual (Page 12)

P 10/16
(5) After successful pairing select “BTC8” from the
Bluetooth device list and press “connect”. After
successful connecting, red LED button will
light up. If your Bluetooth cell phone supports A2DP,
blue LED button will light up as well.
iii. Pairing with a Bluetooth Stereo Transmitter
How to pair a Bluetooth transmitter with the BTC8
depends on the Bluetooth transmitter itself. Please refer
to its user manual for further information. General pairing
steps are as follows:
(1) Keep BTC8 and Bluetooth transmitter within 1 meter
when pairing;
(2) Enter BTC8’s pairing mode (red and blue LEDs
flash alternately);
(3) Turn on your Bluetooth transmitter and enter its
pairing mode;
(4) The Bluetooth transmitter will search for and
connect to BTC8 automatically. After connecting
successfully, the blue LED of button will light
up.
Note:
‹ Every time you turn on BTC8, it will connect to the
last connected Bluetooth device automatically. If
you want to enter its pairing mode, you have to
press and hold the button for about 2 seconds
(red and blue LEDs will flash alternately).
‹ Pairing mode will last for 3 minutes. BTC8 will exit
pairing mode automatically if it cannot connect to
any device within 3 minutes. If you want to continue
pairing BTC8 with Bluetooth devices, please switch
off BTC8 and try pairing again using steps
mentioned above.
‹ If the red or blue LED is on, BTC8 is already
connected to a device and cannot connect to other
devices. If you want to connect BTC8 to another