Izzo Golf tri-daddy-hitting-net - Manual

C C
G
L
I
F
K
F
Image 1
Image 1
Image 2
Insert Pole Connector (L) in the center of
Sleeves (C)(G), where Frame Poles meet.
Insert
Frame Poles that are in the RED
Sleeves (C) into the RED ends of the Pole
Connector (L). Insert Frame Pole that is in
the GREEN
Spine Sleeve (G) into the
GREEN end of the Pole Connector (L).
After solid ends of Frame Poles ( I ) are connected to Pole Connector (L).
Firmly grab opposite end of Frame Pole ( I ), arc Frame Pole ( I ) (Image 1) and
insert Corner Pin (H) into hollow end of Frame Pole ( I ) ( Image 2 & 3). Do this
for all three Frame Poles ( I ). Hitting net is now assembled and should be
standing upright. Please refer to Tri-Daddy images on the front of instructions,
above the “KEY” for reference on how hitting net should look standing upright.
To secure net to ground push Metal Stakes (K) firmly through Anchor Stake
Loops (E) into ground. In order to add extra stability to hitting net, untie Anchor
Stake Draw String (F). Pull opposite end of Anchor Stake Draw String (F) that
has plastic piece attached, at a 45 degree angle away from the hitting net until
draw string is tight (Image 1). Insert
Metal Stake (K) through loop of string that
is threaded through plastic piece of Anchor Stake Draw String (F) (Image 2).
Push Metal Stake (K) firmly into ground at a 45 degree angle away from hitting
net (Image 2). To adjust Anchor Stake Draw String (F) length pull plastic piece
attached to Anchor Stake Draw String (F) toward or away from hitting net.
To disassemble Hitting Net, reverse steps
7 through 1.
Uninstall Hitting Target (A) and fold in
order to fit into Carry Case (M). Remove
all Metal Stakes (K) from ground.
Remove all Corner Pins (H) from
Frame Poles ( I ).
Next remove Pole Connector (L) from
all Frame Poles ( I ).
Disassemble shock corded
Frame Poles ( I ).
Fold hitting net up and roll as tight as
possible in order to fit in
Carry Case (M).
Place Hitting Net into Carry Case (M).
Add Frame Poles ( I ) to Carry Case (M).
Last Add Metal Stakes (K),
Pole Connector (L) and Hitting
Target (A) to Carry Case (M).
1.
2.
3.
4.
5.
6.
7.
8.
To install the Hitting Target (A), Untie draw strings from Hitting Target (A). Slide cord lock
down toward knotted end of string by squeezing the lock between your thumb and forefinger
to open the string hole shown with the orange arrows above (Image 2). Thread opposite end
of string through
Target Grommets (D) shown in orange circles (Image 1 & 2). Tie end of
the string to Hitting Target (A) loops located on the back of Hitting Target (A) in the
corners, use double knot for extra security (Image 3). Repeat steps for other side of Hitting
Target (A). Hitting Target (A) should look as shown (Image 1).
step 4
step 6
step 7
step 5
SET UP INSTRUCTIONS
(continued)
I
H
I
H
Image 2
Image 3
E
Image 1
D D
A
CUSTOMER SERVICE
FOR MORE INFORMATION PLEASE VISIT WWW.IZZO.COM OR CALL 1-800-284-1220
STORAGE INSTRUCTIONS
M
Image 2
D
C
Image 3
A