Accton Technology SIP Gateway VG3300 Series User Manual
Page 21
“WEB” should
be all Capitals
The
gateway’s
IP address
(192.168.0.
2)
On the PC that is connected to the gateway, enter the gateway’s IP address (Default 192.168.0.2)
and press enter. The gateway will then prompt you with a dialogue box requesting that you enter a
password. Use “WEB” (all capitals), for the User field and “123” for the password field that you have
previously configured. Click the OK button; you should now have access to the gateway’s web
based management interface page.
Upon entering the web based configuration interface.
Click on “IP SETTING” at the top of the page and you will see the page as shown in the following
image.
Select PPPoE from the “IP State” pull down menu.
Fill in the “Account”, “Password”, and “Confirm Password” under the PPPoE Settings. You can
obtain this information from your ISP.
Click on the Apply button.
Click the “BASIC” button at the top to go to the BASIC page and select “Warm Start” to restart the
gateway. You can also perform a warm start using the phone by picking up the handset and dialing
“##0000” then “981#”.
After restarting, the gateway will use PPPoE to obtain it’s IP address.
18