beautypg.com

Detaching the front panel, Etaching the front panel – Kenwood DNX7210BT User Manual

Page 8

background image

14

14

15

Return to the Top page

Basic Operations

Return to the Top page

Basic Operations

SD card

DNX7210BT: Press the <0>

button for 1 second to open the

front panel.

0

The panel fully opens.

DNX5210BT/ DNX5510BT:
Detach the front panel.

NOTE

• For how to detach the panel, see

Detaching The

Front Panel (P.15)

.

Hold the SD card as the diagram
below and insert it into the slot
until it clicks.

Notched section

Labeled side

The unit loads the card and playback
starts.

To remove:

Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.

External device

Insert the plug into the AV-IN jack.

1

2

1

D

etaching The Front

Panel

You can detach the front panel to prevent
theft.

Press the <

0> button for

1 second to open the front panel.

0

NOTE

• You can set the front panel to open automatically

when the ignition is turned off. See

Monitor

angle control (P.74)

.

Detach the panel as the diagrams
below.

2

3

1

4

NOTE

• The attaching plate closes automatically in about

10 seconds after the front panel is released.
Remove the panel before this happens.

Detach the panel as the diagrams
below.

1

2

After detaching:

Put the panel in the protective bag
supplied with the unit.

NOTE

• To prevent deterioration, do not touch the

terminals of the unit and faceplate with your
fingers.

• If the terminals on the unit or faceplate get dirty,

wipe them with a clean soft dry cloth.

1

2

1

This manual is related to the following products: