Videoswitch Vi605 - Manual (Page 60)

Digital Recorder
56
11 Technical Data
11.1 Power-On Reset
If you wish to perform a power-on-reset to restore all settings to their factory defaults, press
the
TAG key while you apply power, and keep pressing it until the ViX05 has powered up
and displays
FACTORY RESET. Note that this process will reset all user settings, including
camera titles. The
TAG key will need to be pressed for about 10 seconds.
The factory configuration can also be recalled via the
CONFIGURATION menu.
11.2 Accessories Included
ViX05
Mains Cable
Vi-X2 Alarm Break-out module (Vi405, Vi605)
Vi-X3 Relay/Dome Break-out Module (Vi405, Vi605)
Vi-X4 Alarm/Relay Break-out module (Vi101, Vi205, Vi302, Vi305)
Hard Drive Key
Manual
CAT5 Ethernet Cable
Blank CDs
11.3 Changing the Hard Drive
Hard drives are sensitive mechanical devices that may be damaged by shock or vibration.
Always protect them from shock and vibration when transporting.
Remove power from the ViX05 before removing the hard drive. Wait for 30 seconds for
the drive to stop spinning before moving the ViX05 or removing the hard drive. Moving a
drive that is still spinning can damage it.
The hard drive drawers require a special key to unlock them. This is supplied with the
ViX05. Insert the key, and turn it clockwise to unlock the drive.
To put a hard drive back into the ViX05, make sure that the lock in the drive drawer is in the
unlocked position. Carefully slide the drawer in as far as it can go with the handle in the up
position. Carefully push the handle down such that the drawer is pulled into the drive bay.
When it is properly located, lock the drawer by turning the key counter-clockwise.
After changing a drive, re-apply power to the ViX05.