Videoswitch Vi605 - Manual (Page 46)

Digital Recorder
42
If the DVR is on a network with other computer equipment, a compatible number should be
chosen. You may need to consult whoever is responsible for the network who can assign
you a number.
If you are connecting only to a broadband router, the default IP address should be
satisfactory. The router will also need setting. See our web site for details:
www.videoswitch.co.uk
To set the IP address of the DVR:
[0..9] Enter IP address
[<][>] Move cursor
[^][v] Change digit at cursor
[TAG] Set default IP address
Note that the IP address consists of four numbers separated by dots.
Each number should be entered with no leading zeroes.
For example, an IP address might be: 192.169.0.2
Ports
The DVR has four IP ports. Port 4 has a fixed piort number of 80 and is used to send emails
and alarm center messages. It can also be used for HTTP access. The other ports are used
for remote access from the Vi-Viewer or other client software.
Port1
This port is used for remote access from the Vi-Viewer or other Videoswitch client software.
[0..9] Enter port
[<][>] Move cursor
[^][v] Change digit at cursor
[TAG] Set default port
Port2
This port is used for remote access from the Vi-Viewer or other Videoswitch client software.
[0..9] Enter port
[<][>] Move cursor
[^][v] Change digit at cursor
[TAG] Set default port
Port3
This port is used for remote access from the Vi-Viewer or other Videoswitch client software.
If a Vi-MPEG4 option module is being used via a router, set this port to 8080 typically so the
router can direct HTTP access to the DVR (as well as to the Vi-MPEG4 module).
[0..9] Enter port
[<][>] Move cursor
[^][v] Change digit at cursor
[TAG] Set default port