Anthem Audio AVM 50 - Manual (Page 76)

68
4.12 SLEEP TIMER (Remote Control Only)
If you would like to go sleep while listening to a program or music, the Sleep Timer will turn the
AVM 50 power off after the selected amount of time:
• Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will operate
for that Path only).
• The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle
as follows: Second=60, third=90, fourth=Disabled.
• Once set, the time remaining appears as the number following ‘Zzz’ in the display.
4.13 ENABLE / DISABLE TIMERS (Remote Control Only)
To enable or disable all timers without entering the Setup, press and hold the SLEEP key until the display
shows ‘ALL TIMERS’, then use the
keys to enable/disable.
4.14 STATUS DISPLAY
Press, Release, Press to cycle through display screens that show the following:
• Software version, day, and time.
• Video Input: Resolution and refresh rate of video source, and
copy-protection status – “CP” means copy-protected, “NP”
means not protected.
• Audio Input: Bit rate / sample rate of digital source, or Analog.
• Input Format: Channels in the source.
• Audio Output: Bit rate / sample rate mode of the digital to analog converters.
• Output Format: Channels producing output.
• Mode: Surround mode.
• DD/DTS 5.1 Dynamics: Normal, Reduced, or Late Night.
• Dialog Normalization: Shown if not equal to 0 dB.
• Tone Controls: Enabled, Bypassed, or N/A.
• Sleep Mode: Enabled or Disabled.
• All Timers: Enabled or Disabled.
• Serial Number: If the number on the rear panel does not match this, contact Anthem immediately.
When in ZONE2 or ZONE3, information relating only to the selected Path is displayed.
SLEEP
INPUT
FRT CTR
THX
TIMERS
STATUS
PIP SWAP MOVE
SSP SOURCE
COPY
AUX TAPE
DVD TV SAT VCR
CD
DVD TV SAT VCR
BASS TREBLE BALA NCE
2-Ch
CD
REC
MAIN Z2 Z3
SSP PATH
DY NAMICS
VOLUME CH PRE-SET
FM/AM PRE-SETS
TUNE
SEEK
SOURCE SEEK
LEARN
ENTER MUTE
7 8
0
9
SELECT
SUB
LFE
FM
AM
SUR
RR
SSP OFF
DISPLAY
TO
NE BYPASS
MODE
ON
SCREEN
INFO
GUIDE BACK
SETUP
1 2 3
4 5 6
POWER
6-Ch
SS P PATH
SSP OFF
LAST
SLEEP
INPUT
FRT CTR
THX
TIMERS
STATUS
PIP SWAP MOVE
SSP SOURCE
COPY
AUX TAPE
DVD TV SAT VCR
CD
DVD TV SAT VCR
BASS TREBLE BALA NCE
2-Ch
CD
REC
MAIN Z2 Z3
SSP PATH
DY NAMICS
VOLUME CH PRE-SET
FM/AM PRE-SETS
TUNE
SEEK
SOURCE SEEK
LEARN
ENTER MUTE
7 8
0
9
SELECT
SUB
LFE
FM
AM
SUR
RR
SSP OFF
DISPLAY
TO
NE BYPASS
MODE
ON
SCREEN
INFO
GUIDE BACK
SETUP
1 2 3
4 5 6
POWER
6-Ch
SS P PATH
SSP OFF
LAST
4. OPERATION
continued …