Arcam Logo - Manual (Page 2)

E-2
Important safety instructions
This product is designed and manufactured to meet
strict quality and safety standards. However, you
should be aware of the following installation and
operation precautions.
1. Take heed of warnings and instructions
It is important that you:
A. read all the safety and operating instructions
before operating this speaker.
B. keep this handbook for future reference.
C. follow all instructions and adhere to all warnings
in the handbook or on the speaker.
2. Water and moisture
Do not use this speaker near water.
The presence of electricity near water can be
dangerous – for example next to a bathtub,
washbowl, kitchen sink, in a wet basement or near a
swimming pool, etc.
3. Object or liquid entry
Take care that objects do not fall and liquids are
not spilled, dripped or splashed into the enclosure
through any openings. Liquid-filled objects such as
vases should not be placed on the equipment.
4. Ventilation
Do not block any of the ventilation openings.
Do not place the equipment on a bed, sofa, rug or similar
soft surface, or in an enclosed bookcase or cabinet, since
ventilation may be impeded. We recommend a minimum
distance of 50mm around the sides and top of the
appliance to provide adequate ventilation.
5. Heat
Do not install the speaker near any heat producing
equipment such as radiators, stoves or other
appliances (including other amplifiers) that produce
heat.
6. Climate
The appliance has been designed for use in moderate
climates.
7. Siting the unit
The unit is not designed for placing in a rack or stand.
It should be placed directly on the floor and sited
where electrical and other leads do not cause a trip
hazard.
8. Power sources
The speaker is supplied with a market-suitable
electrical plug. Do not substitute or modify the
supplied plug – see your dealer if a replacement is
required.
This product is a Class II or double insulated electrical
appliance. It has been designed in such a way that
it does not require a safety connection to electrical
earth (U.S. = ground).
The primary method of isolating the Logo speaker
unit from the mains supply is to use the switch on
the rear of the unit. The Logo speaker unit must be
installed in a manner that makes plug disconnection
possible.
9. Power-cord protection
Power supply cords should be routed so that they
are protected against being walked on or pinched,
particularly at plugs and the point where they exit
from the speaker.
10. Protection from electrical storms
Unplug the speaker during lightning storms or when
unused for long periods of time.
11. Abnormal smell
If an abnormal smell or smoke is detected from the
appliance, turn the power off immediately and unplug
the unit from the wall outlet. Contact your dealer
immediately. 12. Cleaning
Unplug the unit from the mains supply before cleaning.
The case should normally only require a wipe with a
soft, dry, lint-free cloth. Do not use paint thinners or
other chemical solvents for cleaning.
We do not advise the use of furniture cleaning sprays
or polishes as they can cause indelible white marks if
the unit is subsequently wiped with a damp cloth.
13. Servicing and repair
Refer all servicing to qualified servicing personnel.
Servicing is required when: the speaker has been
damaged in any way, such as:
A. the power-supply cord or the plug has been
damaged, or
B. liquid has been spilled, or objects have fallen
into the enclosure, or
C. the appliance has been exposed to rain or
moisture, or
D. the appliance does not appear to operate
normally or exhibits a marked change in
performance, or
E. the appliance has been dropped or the
enclosure damaged.
Safety compliance
This product has been designed to meet the IEC
60065 international electrical safety standard.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service
personnel.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘dangerous voltage’
within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
CAUTION: In Canada and the USA, to prevent electric shock, match the wide blade of the plug to the wide slot in the socket and insert the plug fully
into the socket.
safety
guidelines