Alienware Area-51 m5550 - Manual (Page 76)

Alienware Area-51 m5550 Technical Reference
Network Adapter / Ethernet Problems
The Ethernet adapter does not work
• Go to [Start > Settings > Control Panel > System > Hardware > Device Manager].
Double-click on Network Adapters and check if Realtek RTL8510EX Family
Fast Ethernet NIC appears as one of the adapters. If it does not exist, Windows
has not detected the Realtek RTL8510EX Family Fast Ethernet NIC or
the device driver has not been installed properly. If there is a yellow mark
or red cross on the network adapter, it may be a device or resource conflict.
Replace or update the device driver from the factory CD-ROM disk or
consult the Windows manual on how to solve the resource conflict problem.
• Make sure the physical connections on both ends of the cable are good.
• The hub or concentrator may not be working properly. Check to see if other
workstations connected to the same hub or concentrator are working.
The Ethernet adapter does not appear to operate in the 100/1000Mbps
transmission mode
• Make sure the hub you are using supports 100/1000Mbps operation.
• Make sure that your RJ-45 cable meets the 100/1000Base-TX requirements.
• Make sure the Ethernet cable is connected to the hub socket that supports
100/1000Base-TX mode. The hub may have both 100Base-TX and 1000Base-
T sockets.
m5550-04-2007-techref.indd 76 4/6/2007 12:29:53 PM