beautypg.com

Operating instructions, Controls, Remote control signal receiver power mode – LG LT081CNR User Manual

Page 18: Timer, Temperature setting, Fan speed

background image

18 Room Air Conditioner

Operating Instructions

Operating Instructions

Controls

The controls will look like one of the following.

MODE

TIMER

POWER

FAN

SPEED

Fan

Energy

Saver

Cool

Timer

TEMP

'

F

F1 LOW
F2 MED
F3 HIGH

REMOTE CONTROL SIGNAL
RECEIVER

POWER

MODE

-

Push this button to shift mode of operation from COOL

→ ENERGY SAVER → FAN.

- COOL:

• Fan runs continually for normal cooling operation.

- ENERGY SAVER:

• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will

check the room air temperature to determine if cooling is needed.

- FAN:

• Fan-only operation.

TIMER

- SHUT-OFF TIME

• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature

setting will raise 2

°F after 30 min., and once again after another

30 min.

• Push Timer button to advance setting from 1Hour

→ 2Hours → ...

→ 24 Hours maximum.

- START TIME

• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour

→ 2Hours → ...

→ 24 Hours maximum.

TEMPERATURE SETTING

• Use this button to automatically control the

temperature of the room.
The temperature can be set within a range of
60

°F to 86°F by increments of 1°F.

• The setting appears in the display.

• To turn the air conditioner ON, push this button.

To turn the air conditioner OFF, push the button
again.

• This button takes priority over any other button.
• When you first turn it on, the unit is in cool

mode, High fan speed, Temperature setting at
72

°F.

FAN SPEED

• Every time you push this button, it advances the setting as follows: {High

→ Low → Med → High}

AUTO RESTART

When power is restored after an electrical power failure, the unit will begin to run at its last setting.