ASKO D3152 - Manual (Page 20)

20
Customer Care Center
1-800-898-1879
www.askousa.com
Rinse aid
Adding rinse aid
In some cases, drying can be made more ef-
ficient by using rinse aid.
Machines with indicator on the panel
When the rinse aid has run out and more is
needed, the rinse aid symbol on the panel
lights up*.
To fill with rinse aid:
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the amount
of rinse aid to be dispensed in each wash.
2. Carefully pour in rinse aid up to the dos-
age setting knob.
Alter dosage if required. Do not forget to
close the cover.
*Note!
After filling there may be a short delay be-
fore the signal light goes out.
Machines with refill indicator
There is a refill indicator in the middle of the
dispenser (see illustration). If the refill indica-
tor is totally black, there is sufficient rinse
aid. However, if the indicator has a more
transparent appearance, you need to top up
with rinse aid (see above).
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness,
you may need to change the dosage.
Open the rinse aid cover. Here you will find
the dispenser’s adjustment dial. Settings 1-6:
the harder the water, the higher the dosage.
When the water hardness exceeds 10-12 o dH,
you should use rinse aid with citric acid (acid
rinse aid) if the machine does not have a wa-
ter softening filter. If the machine has a water
softening filter, dispense as for soft water.
Too much rinse aid can lead to the build-
up of foam. If your water is particularly soft,
you can dilute the rinse aid (1 part rinse aid,
1 part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in water
stains.
Open
Closed
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!