Ameriphone XL-25s - Manual (Page 6)

Setting up Your
Dialogue XL-25s
There are four steps involved in
setting up your Dialogue XL-25s.
• Insert one 9 volt alkaline battery
for extra bright ring flasher
(optional)
Note: For your safety always unplug the
phone line before you install or replace
the backup battery.
• Decide if you want the phone to
sit on a desk or hang on the wall.
• Connect the telephone components.
• Program up to to 12 telephone
numbers to call with the press of
a memory button.
• Setup special features
Installing the Backup Batteries
To add extra brightness to the
Dialogue XL-25s’s ring flasher when
you receive calls, install one 9 Volt
alkaline battery (not included).
Note:
For your safety always unplug the
phone line before you install or replace
the backup battery.
To install new battery:
1. Slide open the battery compart--
ment cover on the bottom of the
telephone, (Figure 3).
2. Install one fresh 9-volt battery.
The battery indicator on the
base unit will light up if the
battery is running low.
Setting the Dial Mode
Set the dial mode switch to T (tone)
if you have touch tone service.
Set the switch to P (pulse) if you have
rotary dialing.
Connecting for Desk or Wall Mount
Desktop Use
1. Connect the telephone line cord
and the handset cord to the
telephone as shown in Figure 4.
Figure 4 - Connecting the
Components
4
Figure 3