HT instruments HT3310 - Manual (Page 12)

HT3301-HT3310
EN - 11
6.1.2. Type K measurement mode (HT3301 only)
1. Pressing the MODE button, select the “TK” symbol according to paragraph 4.4.1
2. Disable laser beam using the Laser/Backlight key
3. Connect the K Type probe to the corresponding inputs respecting the polarity marked in
the socket and in the plug.
4. Pull and hold the trigger to turn the meter on and begin testing. The display will light if
the battery is good. Replace the battery if the display does not light. While measuring,
the SCAN display icon will appear in the upper left corner of the LCD. The temperature
detected by the probe will be displayed in the small display on the LCD low-right corner.
5. Release the trigger and the HOLD icon will appear on the LCD indicating that the
reading is being held
6. The meter will automatically power off after approximately 7 seconds after the trigger is
released.(Unless the unit is locked on)
7. MEMORY (HT3301 only)
7.1. STORING RESULTS
1. To store data from an infrared reading, pull the trigger. While holding the trigger, press
the MODE button until LOG appears in the lower left corner of the display
2. A log location number will be shown. If no temperature has been recorded in the shown
LOG location, 4 dashes will appear in the lower right corner
3. Aim the unit at the target area you want to record, and press the laser/backlight key
4. The recorded temperature will appear in the lower right corner. To select another log
location, press the up and down keys. Your thermometer is capable of storing up to 20
data locations. The infrared temperature and temperature scale (°C or °F) are also
stored
7.2. RECALLING DATA
1. To recall stored data after the unit shuts off, press the MODE button until LOG appears
in the lower left corner
2. A LOG location number will be shown below LOG, and the stored temperature for that
location will be display
3. To move to another LOG location, press the UP and Down keys
7.3. CLEAR DATA
1. Press the MODE button until the LOG mode is selected
2. While in LOG mode, press the trigger, and then press the “down” arrow button until you
reach LOG location “0”. This can only be done when the trigger is pulled. LOG location
“0”cannot be accessed, by using the “up” arrow button.
3. When LOG location “0” shows in the display, press the laser/backlight button. A tones
will sound, and the LOG location will automatically change to “1”, signifying that all data
locations have been cleared.