WEN 56206 6 Ton Electric Log Splitter - Manual (Page 17)

17
TROUBLESHOOTING
Use this troubleshooting information to remedy problems that may occur during the operation of
the log splitter.
Problem Cause Action
Logs will not
split Extension cord is too long or
gauge is too low Check extension cord to ensure the gauge
of the cord is 12or 14 AWG and that the
cord length does not exceed 25 ft.
Incorrect positioning of the log. Make sure the log is properly positioned
on the worktable (See page 13, "Place a
log on the log splitter ")
The size or hardness, or density
of the log may exceed the
capacity of the splitter. Reduce the log size before placing it on
the splitter.
Splitting wedge cutting edge is
blunt or dull Sharpen the wedge (See page 16,
"Sharpen the splitting wedge")
The bleed screw was not
loosened and air is trapped in the
hydraulic tank Loosen the bleed screw one or two turns
The hydraulic fluid is low and
may need to be replenished Check the hydraulic fluid level and refill
if needed
The maximum pressure limiting
adjustment setting has changed Contact a trained service Technician at 1-
800-232-1195
Hydraulic fluid
leaks The bleed screw may not have
been tightened before
transporting the splitter Tighten the bleed screw
The bleed screw may not have
been loosened before operation
and air is trapped in the
hydraulic system Loosen the bleed screw one or two turns.
The fluid drain knob may be
loose. Tighten the knob
The hydraulic control valve
assembly and/or seals may be
worn. Contact a trained service Technician at 1-
800-232-1195
Push rod
movement is
jerky, makes
unfamiliar noise
or vibration The hydraulic fluid level may be
low. Check the fluid level and refill, if needed.
There may be air in the hydraulic
system. Loosen the bleed screw one or two
rotations.