ShelterLogic 26764 18 x 40 Super Max Canopy - Manual (Page 2)

PAGE 2
1. Frame Assembly
4. Attaching Legs 3. Place Cover
Side Bend Connectors
(sharp bend)
Top Crest Connectors
(shallow bend)
802105 802105 802104 802104
802105 802105 802104 802104
802105 802105 802104 802104
802105 802105 802104 802104
802105 802105 802104 802104
802105 802105 802104 802104
802105 802105 802104 802104
10048
10046
10046 10048
10045
10045 10047
10045
10046 10045
10047
10044 10044 10044
10044 10044 10044
10044 10044 10044
10044 10044 10044
10044 10044 10044
10044 10044 10044
10047
10045
10048
10047 10047
10048
10047 10047
10048
10047 10047
10048
10047 10047
Assembly is easiest if you layout all parts as
shown. There are (14) #802105 Rafter Poles ,
they are swedged on both ends. (14) #802104
Rafter Poles, they are swedged end. The (18)
#10044 Cross Poles do not have swedged
ends. It is very important that you determine
which of the 3 & 4 way connectors are meant
for the sides and which are for the crest.
assembly together as shown in Fig. 1A. Assemble each side of the roof as shown in Fig. 2. Install #802103 truss
as shown in Fig. 2A.
Start with center, Fig. 1, using layout shown in diagram above. Bolt roof
Assemble Roof
Fig. 2
10043
Fig. 1
Note: Install all carriage bolts
with nut toward center of frame.
01010
10017
Fig. 1A
Place cover over frame so that the
grommeted portion is face down,
this allows the valance to wrap
around and cover the frame eaves.
Insert #10043 Leg Poles on one side of the frame, swedged
end up, then the end legs on that same side. Repeat for the
other side. Now you can secure the legs to the side bend
connectors and secure the cover with bungee cords.
10017
7000
Fig. 2A
802103