Audiovox PRESTIGE PMC-50 - Manual (Page 9)

NOTES ON REMOTE CONTROL USE:
The remote control operates on a 3 volt lithium battery (type
CR-2025). Install the battery into the compartment at the
bottom of the remote control, making sure to observe
correct polarity (match “+” side of battery to “+” indication on
compartment).
If remote control fails to operate, always check battery
condition and replace if necessary before servicing the unit.
Dispose of batteries properly. Do not heat, disassemble, or
throw batteries into a fire.
Keep the remote control away from areas where it may be
exposed to heat, moisture or sunlight.
9
INFRARED SENDER
The wireless signal from the remote control is sent from this lens.
For optimal range and performance of the remote control, always
aim the Sender at the Remote Sensor
bm
on the wired com-
mander. Do not let your finger interfere with the signal and make
sure the lens does not become blocked by dirt, dust, etc. If
necessary, clean the lens with a soft dry cloth or cotton swab.
7
TRACK/DISC SHUFFLE (SHF)
See wired Commander
8
8
TRACK/DISC (SCN)
See wired Commander
9
8