Progressive International Electronics EZ Wire DBox - Manual (Page 5)

PI DBox Installation Guide
Version 5.0 January 2012
Page 1
System Installation
System Installation Warnings
Safety hazards are inherent with all electrical equipment. Standard precautions must be taken at all
times during installation and operation of the O
MEGA 2 units. In addition to normal electrical
precautions, the following points should be noted during installation.
C Installation must comply with National Electrical Code, as well as Federal, State/Provincial,
Local, and all applicable codes.
C High voltages are present in the PI DBox components, as well as the equipment to which it is
attaching. To prevent personal injury or equipment damage, disconnect all power before
proceeding with installation.
C PI DBox must be installed in nonvolatile, noncombustible, nonexplosive areas. The box must
be protected from severe vibration, extreme temperatures and excessive humidity.
C All PI DBox and associated equipment must be installed in nonhazardous locations and must
be UL-listed, using standard communication.
For Use in USA
Installation of the PI DBox and associated equipment must comply with the requirements of the
National Electrical Code (NFPA 70), the Automotive and Marine Station Code (NFPA 30A), and all
Federal, State, Local, and applicable safety codes.
For Use in Canada
Installation of the all fuel control equipment must comply with the requirements of the Canadian
Electrical Code, the Flammable and Combustible Liquid Code, and all Federal, Provincial, State,
Local, and applicable safety codes.
The installation of the systems covered by this manual in conjunction with equipment not UL Listed has not been evaluated by the
Underwriters Laboratories and is outside the intended use of this equipment. Warning: All dispensing equipment discussed in this
manual is not UL Listed and the combination has not been evaluated by Underwriters Laboratories.