7 hdd installation (af-12a-n270 only), Nstallation, Af-12a-n270 – IEI Integration AFL-xxA-N270-Series v2.00 User Manual

Page 49: Figure 4-5: af-12a-n270 hdd retention screws

AFL-xxA-N270 Series Panel PC

Page 34

4.7 HDD Installation (AF-12A-N270 Only)

To install the HDD into the AF-12A-N270, please follow the steps below:

Step 1:

Remove the plastic back cover. See Section 4.5 above.

Step 2:

Remove the aluminum cover. See Section 5.4.2.

Step 3:

Remove the four HDD bracket retention screws and lift the HDD bracket off the

panel PC.

Step 4:

Attach the HDD brackets to the HDD. To do this, align the four retention screw

holes in the both sides of the HDD bracket with the retention screw holes on the

sides of the HDD. Insert four retention screws into the HDD bracket

Figure 4-5: AF-12A-N270 HDD Retention Screws

Step 5:

Connect the SATA cable to the rear of HDD and the SATA connector on the

motherboard.

Step 6:

Install the HDD into the AF-12A-N270 by aligning the retention screw holes in

the HDD brackets with the retention screw holes on the chassis. Insert the four

retention screws.

Step 7:

Replace the aluminum back cover to the chassis.

Step 8:

Replace the plastic back cover.

Step 0: