IEI Integration AFL-4 series-N270 v2.20 - Manual (Page 49)

AFL-4 Series-N270 User Manual
Page 49
4.9 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the AFL-4
Series-N270. Before the AFL-4 Series-N270 is installed, the jumpers must be set in
accordance with the desired configuration. The jumpers on the AFL-4 Series-N270
motherboard are listed in Table 4-1.
Description Label Type
ATX/AT power mode JP4 2-pin header
Clear CMOS J_CMOS1 3-pin header
COM3 RX RS-232/422/485 select JP6 12-pin header
COM2 RS-232/422/485 detect JP9 8-pin header
LCD backlight select J_BL1 3-pin header
LCD power select 1 J_VLVDS1 3-pin header
LCD panel type JP14 2-pin header
MCU LCD panel type JP13 3-pin header
MCU LCD type select JP17 2-pin header
Touch screen select J1 4-pin header
Table 4-1: Jumpers