5 removing the rear panel, 6 cf card installation, Emoving the – IEI Integration AFL-4 series-N270 v2.20 User Manual

Page 45: Anel, Nstallation, Figure 4-1: back cover retention screws

AFL-4 Series-N270 User Manual

Page 45

4.5 Removing the Rear Panel

To access the AFL-4 Series-N270 internally the rear panel must be removed. To remove

the rear panel, please follow the steps below.

Step 1:

Place the AFL-4 Series-N270 face down on a flat surface.

Step 2:

Remove the retention screws (Figure 4-1).

Figure 4-1: Back Cover Retention Screws

Step 3:

Lift the cover off and pull down the cover a bit to make it possible to lift the cover

further more after removing the retention screws. More strength is required to

separate the cover from the chassis.

Step 0:

4.6 CF Card Installation

The AFL-4 Series-N270 has one CF Type II slot inside the rear panel. The slot can be

accessed without removing the back cover. To install the CF card, follow the instructions

below.