1 memory module replacement, Eplacing, Omponents – IEI Integration AFL-4 series-N270 v1.05 User Manual

Page 75: Figure 5-1: back cover retention screws, 5 replacing components

AFL-4 Series-N270 User Manual

Page 75

Figure 5-1: Back Cover Retention Screws

Step 5:

Lift the cover off and pull down the cover a bit to make it possible to lift the cover

further more after removing the retention screws. More strength is required to

separate the cover from the chassis.

Step 0:

5.5 Replacing Components

5.5.1 Memory Module Replacement

The flat panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory

module is fail, follow the instructions below to replace the memory module.

Step 1:

Remove the aluminum back cover. See Section 5.4.1 above.

Step 2:

Locate the DDR2 SO-DIMM on the motherboard (Figure 5-2).