Aga Ranges SIX-FOUR DC6 - Manual (Page 11)

A stability bracket shall be secured firmly to the fabric of the building. For positioning of bracket
(See Fig. 3). A safety chain should also be anchored firmly to the wall and cooker to prevent
strain on the gas connection, when the cooker is withdrawn for servicing. When fitting a stability
bracket and chain refer to Fig. 3, 3A and 3B.
Ranges must have an anti-tip bracket correctly installed as per these instructions. If you pull the
range out from the wall for any reason, make sure that the device is properly engaged when you
push the range back against the wall. If it is not, there is a possible risk of the range tipping over
and causing injury if you or a child stand, sit or lean on an open door.
If disconnection of the restraining chain is necessary then ensure restraining chain is reattached
as appliance is relocated in its original position.
To reduce the risk of tipping, the range must be secured by a properly installed anti-tip bracket
supplied with the range. The bracket must be fitted within the shaded area shown in the diagram
using 2 x screws (No. 10 x 1 1/4”) fixed in the wall or floor, longer screws may be required
depending on the wall or floor covering.
Fig. 3A
Fig. 3B
DESN 512638
11
COOKER STABILITY
CENTRE LINE OF
COOKER
BRACKET
FLOOR
WALL
SIDE VIEW