Amana AMC7159TA - Manual (Page 7)

7
MICROWAVE OVEN CONTROL
Display
When power is first supplied to the microwave oven, a “:” will
blink in the display. Touch OFF/CANCEL to stop the blinking.
If the “:” blinks in the display at any other time, a power failure
has occurred. Touch OFF/CANCEL and reset the clock if needed.
If “RETRY” blinks in the display for 1 second, an invalid value has
been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day.
Scroll speed may be adjusted, and the language may be
changed. See “Options” section.
Start/Enter
The START/ENTER control will start any function.
If non-sensor cooking is interrupted, touching START/ENTER will
resume the preset cycle. A sensor cooking cycle may not be
resumed if interrupted by opening the door.
The START/ENTER control shares function with the JET START
control.
Jet Start Feature
The JET START control (START/ENTER pad) automatically starts
the microwave oven at 100% power for 30 seconds, and adds
30 seconds of cook time, up to 3 minutes, then 1 minute of cook
time, up to 10 minutes with each additional touch of the control.
Time may be added in 30-second increments to any cooking
cycle, at the current power level, by touching the JET START
control during cooking.
Off/Cancel
The OFF/CANCEL pad clears any incorrect command and
cancels any program during cooking. It will not erase the time of
day.
The microwave oven will also turn off when the door is opened.
Close the door and touch START/ENTER to resume the cycle. A
sensor cooking cycle may not be resumed if interrupted by
opening the door.
The OFF/CANCEL control shares function with the Control Lock.
Control Lock
The Control Lock shuts down the control panel pads to avoid
unintended use of the microwave oven.
To Lock/Unlock Control: Before locking, make sure the
microwave oven and Timer are off. Touch and hold OFF/CANCEL
for 4 seconds until 1 tone sounds and “LOCKED” appears in the
display. Repeat to unlock. “UNLOCK” will appear in the display
and 2 tones will sound.