Innovative Tools & Technologies Innovative UltraRack™ Paint Stand - Manual

UltraRack
Usage Instructions
Hood
Important! Before usage, make sure all four Total Lock Caster Wheels are set in the “brake on”
position (P/N 220-024). All parts must be centered and mounted in the vertical position. All Hand
Knobs must be securely tightened before rotating to desired position. Height adjustment on Frame
Post (P/N 220-003) should be made prior to mounting part.
Step 1: Set
all four Total Lock Caster Wheels to “brake on” position (P/N 220-024).
Step 2: Adjust UltraRack to vertical position (see photo 1).
Step 3: Adjust upper Tee Frame Tube to desired height (P/N 220-007) using Quick Release Pin
(P/N 220-030). Note: average setting for hood is fourth to seventh pinning hole from top of upper Tee Frame.
Step 4: Loosen all four Hand Knobs on upper and lower Tee Frame Tubes.
Step 5: Adjust width of upper right and left Support Arms to desired hole locations on hood, set hood
on upper right and left Support Arm hooks. Securely tighten upper Hand Knobs (see photo 2).
Step 6: Loosen lower Tee Frame Tube (P/N 220-006). Adjust width of lower right and left Support
Arms to desired hole locations on hood, set lower Support Arm hooks in desired hole locations.
Securely tighten Hand Knobs.
Step 7: While applying firm downward pressure to lower Tee Frame Tube, securely tighten Tee Handle.
Step 8: Make sure all Hand Knobs and Tee Handles are securely tightened.
Step 9: To rotate hood from vertical position, apply slight
downward pressure while pulling Rod
Handle (P/N 220-012). To rotate hood back to vertical position, apply slight upward pressure while
pulling Rod Handle.
Left upper Support Arm hook
inserted into hood (see photo 2).
Photo 1
Photo 2
Innovative UltraRack™