Securitron M34R_Series - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-13800
Page 1 Rev. D, 04/11
RECESSED MAGNALOCK MODEL M34R SERIES
INSTALLATION AND OPERATING INSTRUCTIONS
1. INTRODUCTION
The Securitron Series of Recessed Magnalocks were designed for installations where concealed,
mortise type mounting in the door and frame is desired. The M34R was designed to operate
primarily with sliding type doors and are usually installed vertically for proper operation.
The M34R lock is also available with the following features:
The BondSTAT “B” Series, Bond Sensor, monitors the magnetic field. An internal sensor
activates a SPDT dry contact relay connection designed for interface to access control and/or
alarm systems for reporting the status of the Magnalock. (See Section 5.5.2)
The DPS “D” Series, Door Position Sensor, is activated by a special magnetic strike armature
assembly. The isolated SPDT reed switch, with an internal resettable protection device, is
designed for interface to access control and/or alarm system for door status. (See Section
5.5.2)
2. SPECIFICATIONS
MODEL M34R
Holding Force 500 Lbs [227 kg]
Dimensions: Length 10.55" [275mm]
Height 1.5" [38mm]
Depth 1.19" [30mm]
Dual Voltage 12/24 Volts DC
Current: @ 12 VDC 320mA
@ 24 VDC 170mA
Capacitance: @ 12 VDC 6.8 mF
@ 24 VDC 6.8 mF
BondSTAT Rating
Voltage: 30 VDC (Maximum)
Current: 1 Amp (Maximum)
DPS Rating
Voltage: 30 VDC (Maximum)
Current: 125 mA (Maximum)
3. PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required
components and hardware have been included. Along with these instructions and the
installation template, each product should include the following items:
Figure 1 – M34R Series Magnalock
Magnalock
Strike Plate
Hardware Pack