IQinVision Alliance-mini Series IQD5x - Manual (Page 5)

6 Mounting on an Interior Durable Surface Wall
1. Remove the trim cover
Using the supplied Torx T-10 security wrench loosen the two tamper-
proof screws holding the dome cover to the camera assembly. Note
that these screws are not captively held to the dome cover. If lost, two
spare tamper-proof screws are provided. If using a PoE Ethernet cable
coming through the wall, be sure to run this cable through the cable
pass-through in the camera base plate and connect it to the Ethernet
port on the camera as shown in Image 6.1.
Note: The included internal microphone is disabled by default.
If an external microphone or powered loudspeaker (not supplied) will
be connected to the mini dome camera use the supplied audio cable.
Pass the audio cable through the camera base plate and connect it
to the audio connector on the camera as shown in Image 6.2. External
microphone and powered loudspeaker will connect to the 3.5 mm
plugs.
2. Mount the Alliance-mini camera base to the desired wall or ceiling
surface using the supplied or equivalent mounting hardware.
Image 6.1
5
Side 1 Side 2 Cover Removal Ethernet Pass-Through
Image 6.2