INSTEON Micro Dimmer - 2442-222 (US), 2442-422 (EU), 2442-522 (AUS/NZ) Manual - Manual (Page 9)

Page 9 of 24 2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM
Local Control Operation
Micro module’s switch operation mode affects how it responds to commands from the switch. This is why
it’s important to program Micro module for the specific type of switch you are using. Micro module’s on/off
buttons function exactly like the top and bottom of your wall switch.
Latching Switch (Default)
Note that this table refers to the latching switch operation if 3-way toggle mode is disabled (it is enabled
by default).
Single Momentary Switch
Dual Momentary Switch
Connected load/responders
Latching switch Tap LED
Top
On
(ramped)
Green
Bottom
Off
(ramped)
Red
Connected load/responders
Single momentary switch Tap Press and hold Double-tap LED
Switch
On/Off
(ramped)
Brighten/Dim
until release or full-on/off
(dimmable responders only)
On/Off
(instant)
Green/
Red
Connected load/responders
Dual momentary switch Tap Press and hold Double-tap LED
Top
On
(ramped)
Brighten
until release or 100%
(dimmable responders only)
On
(instant)
Green
Bottom
Off
(ramped)
Dim
until release or off
(dimmable responders only)
Off
(instant)
Red