Preparing control surfaces – Biamp A4 User Manual
Page 84
daVinci Printed Doc
82
Preparing Control Surfaces
Typically, there will be one or more dedicated computers connected to the
, with daVinci
software running, and user access to the control surface available via
. This requires
that the control surface first be
to the system.
The control surface is initially sent to the system by the
, who can utilize certain
to prepare the control surface for the end-user. These Application Controls
would have been included in the control surface design, and assigned to a restricted
. The Administrator can use these controls to put the control surface into a 'user
mode' (such as Full Screen), which the end-user cannot exit from. The Administrator will then
Logout of the control surface, leaving it active on the computer(s) for user
. NOTES:
Login/Logout may also be assigned to Application Controls on the control surface, which can be
made accessible to the end-user. Full Screen mode can be automatic whenever control surfaces
are opened or tested, as selected under