ATEN VS481 - Manual (Page 8)

- 8 -
Hardware Installation
Before you Begin
Installation of this HDMI switch is simply a matter of plugging in
the appropriate cables.
To install the switch, refer to the installation diagram on the next
page as you perform the following three steps:
1. Use HDMI cables to connect the HDMI input connector on the
video display device to the HDMI output connector on the rear
of the switch.
2. Use HDMI cables to connect the HDMI output connectors on
the source device(s) to the HDMI input connectors on the
switch.
3. If you have a DVI source device, use a DVI-D cable to
connect the DVI output connector on the source device to the
DVI input connector on the switch.
4. Plug the provided power adapter into an appropriate AC
power source; plug the power adapter cable into the Power
Jack on the HDMI Switch.
This completes the installation. You may now turn on the display
and source devices.
1. Ensure that all equipment to be connected is pow-
ered off.
2. Make sure that all devices you will be connecting up
are properly grounded.
3. Unplug the power cords of all the computers that
have the Keyboard Power On function.
VS481.fm Page 8 Monday, July 17, 2006 1:15 PM