Lexibook DJ033 Series - Manual (Page 18)

English
18
1. Press the Power button (9) for about 3 seconds to turn the camera on.
The LED will light up for a moment and the camera will sound a beep to
confirm that it is ready for use.
2. Press and hold the Power button (9) for about 3 seconds again to turn it off.
Note: The camera will auto power off after a few seconds of inactivity.
TURNING THE CAMERA ON AND OFF
You are already in camera mode when you switch on the unit:
1. Press the Shutter button (1) to take a photo. The camera will beep twice
to confirm that a picture is taken.
2. To check the number of pictures you have left to take, the battery level
or resolution, press the Menu button (9) once in camera mode. Wait a
few seconds to automatically go back to the camera mode.
Note:
• When the camera’s built-in memory is full, if you try to take a photo, the
LCD screen will display a warning message.
• When the SD card inserted in the camera is full, you will not be able to
take new photos. Make sure you transfer all your photos to your computer.
TAKING PHOTOS
Switch on the camera:
Auto flash
1. In camera mode, press the Down/Flash button (10) until the icon
appears on the lower left corner of the LCD screen. The auto flash
function will be activated.
Flash on
2. In camera mode, press the Down/Flash button (10) until the icon
appears on the lower left corner of the LCD screen. The flash function will
be activated.
Flash on
3. In camera mode, press the Down/Flash button (10) until the icon
appears on the lower left corner of the LCD screen. The flash function will
be disabled.
FLASH FUNCTION
DJ033seriesIM1210.indb 18 25/05/2010 6:31