I-View Ethernet/PoE over Coax Extender User Manual
Page 2

Installation Steps:
1. Connect the EPOC-101VA_Tx unit's (Which on the IP camera site) RJ45 Ethernet jack to the IP camera using a
standard Cat5 or Cat6 patch cable and unit's BNC socket to a 75 ohm coax cable with BNC connector.
2. Plug power core (come with package) into the power jack between EPOC-101VA_Tx and IP camera.
3. Connect the EPOC-110VA_Tx (Which on the HUB site) BNC socket to a 75 ohm coax cable with BNC
connector, then plug the a standard Cat5 or Cat6 patch cable to the unit’s RJ45 Ethernet jack to Switching HUB.
4. Check all the cable connection is correct before you plug the DC 48V power adapter (comes with package) to the
EPOC-101VA-Rx.
5. In order to get better transmission distance, the Ethernet patch cable should be a standard Cat5 or Cat6 cable and
less than 2 meters.
Troubleshooting:
The following table describes some of the symptoms, probable causes and possible solutions
Problem Possible
Cause
Hub LED indicator is
OK, but no video
9
Check IP camera and EPOC-101VA_Tx cable connections.
9
Check coax cable condition and BNC connectors is 75 Ohm.
9
Check that supplied camera power meets EPOC-101VA_Tx unit’s specifications.
9
Check cable that cable impedance does not exceed 39 Ohm
9
Check cable that cable distances do not exceed EPOC-101Kit operating distance.
9
Check that the plug in power adapter on the EPOC-101VA_Tx unit is DC 48V..
9
Check the built in jumper cable of IP camera used non- standard Cat. 5 cables.
9
Check that the camera is powered.
Network lost
9
Check network switch termination(s) & link status.
9
Check network routing table(s).
9
Confer with site Network Administrator.
Specification:
Phone: 886-3-510-3001 Fax: 886-3-510-3002
Mail: [email protected]
Item \Model
EPOC-101VA_Tx
EPOC-101VA_Rx
Ethernet
Connector: RJ-45
Speed: 10/100Base-T full-duplex
Coaxial
Connector: BNC 75 Ohm
Cable: Any 75 Ohm coax cable
Distance: 300 meters (Typ.)@ full rate via RG59U coax cable
Bandwidth: 100M bits/Second
Power
Device Power: DC 12V / 50mA
POE In / Out: DC 48V / None
Device Power: DC 12V / 50mA
POE In / Out: None / DC 12V@1A
Dimension /Weight
100 x 55 x 34 mm / 150g
100 x 55 x 34 mm / 140g
Environment
Operation: 0℃to 50℃; 20%
~
85% non-condensing