Alpha Technologies CORDEX QUICK REFERENCE CARD—SOFTWARE VERSIONS 2.0 AND GREATER - Manual (Page 2)

The “Option” button is used
to Logout or Save changes
Option
The branches of this tree show the structure or possible paths
from the Main Menu through the submenus; which contain
items that can be invoked to configure properties, perform
control functions, view parameters, etc.
- MANUAL PROVIDES DETAILS -
Some items are highlighted here to provide a visual cue for
functions and tasks most commonly used.
Configure... (Name of Alarm or Control)
Customize...
[activation, value, source ]
Relay Mapping [1-16]
Priority [major / minor / message]
Allow Alarm To Be Cutoff, Enable Alarm
Email, SNMP [severity],
as required
Controller Signals
Analog Inputs [V1-2, I1-4, GP1-4]
Digital Inputs [1-8
]
Rectifier Signals [ ]
Custom Signals [1-10, (Customize)]
Converter [ ], Counter, Timers, ADIO
view status
view status
view status
Configure
Rectifier, Digital, Current, Voltage, Battery,
Temperature, Miscellaneous, ADIO, Custom,
Converter,
(Customize) Configure
Supervisor
Change Password [Supervisor, User]
Hardware
Configure Relays [1-16, toggle polarity]
Test Relays [1-16, toggle state]
Communications
IP Info [IP addr, subnet mask, gateway, MAC]
[obtain automatically, settings]
Modem [baud rate, rear port, init string]
Craft Port [baud rate]
Web Settings [routing]
Master SNMP Destination
IP Address
Controls
[1-10, voltage, mapping...]
LVD Inhibit [status, mapping...]
HVSD [activation value, mapping...]
CEMF [voltages, mapping...]
LVD Control
Signals
Calibrate Analog Inputs
Configure Signals
Alarms
Configure ALCO, ADIO Alarms Detail
Alarm Hysteresis [voltage, time]
Alarm Tone [enable...]
Configure Alarms
Batteries
Temp Comp [enable, breakpoints...]
Auto EQ [duration, interval, threshold...]
Charge Current Control [enable...]
Battery Monitor [enable...]
Battery Test [voltage, timeout, interval...]
BCT EQ [enable, duration, threshold]
Boost Mode [enable, voltage, timeout...]
Battery Properties, Battery Information
Rectifiers
Rectifier Report
Power Save [enable...]
Phase Mapping [locate...]
Configure Settings Serial Num. Amps Alarms Out of Tolerance
[rectifier alarms, out of tolerance]
Float Voltage, Equalize Voltage, BT Voltage, Safe
Voltage, OVP, LVA, HVA, Current Limit, Power Limit
EQ Timeout, BT Timeout, Slope, Backlight Timeout
Security Code, Module & System Start Delay
Softstart Ramp Rate [normal / fast]
Temp Display Scale [C / F]
Current Limit (CL) and Power Limit (PL) Alarm
Remote Shutdown, Local Access Alarm
Ramp Test
View Details
Converters
Converter Report
Configure Settings
Serial Num. Amps Alarms Out of Tolerance
[converter alarms, out of tolerance]
Output Voltage, OVP, Input Voltage Shutdown,
Input Voltage Restart, Start Delay,
Current Limit (CL) Alarm, Ramp Test
View Details
System Info
System Configuration
CAN Device FW Upgrade
Set ADIO Module Number [1-16]
Site Information
Temperature Units [C / F]
Factory Information
System Voltage [12V, 24V, 48V, 125V, 220V]
Use Firmware [perform upgrade]
Load From Device [get firmware]
System Number, Serial,
Unit Serial, Hardware Rev., Ethernet/MAC Address
Factory Notes
Contact Information
MAIN MENU
CXC M T ENU REE