IMP Pumps NMTC module - Manual (Page 30)

30
• Input 2
You can combine different settings (i.e.: Limit Power and Limit Head) and by doing that, shape the Q-H
curve to your liking.
On the bottom right side of the page three buttons are located: SAVE, TEST and RESTORE. The SAVE
button is used to save the current set values into permanent memory, while the TEST button is used to
apply changes to the pump without saving the set values into memory (only to check how possible
changes affect the pump). The RESTORE button retrieves the saved settings from memory.
Network page:
This page is used for adjusting the network settings of the pump.
You can change the following values:
• Pump IP address
• Subnet mask
• Default gateway
• NetBIOS name
• Twin mode with IP
The SAVE, TEST and RESTORE buttons work in the same way as on the Pump page.
Log Page
This page is used to monitor and check if the pump is reporting any errors (Errors are also displayed by
the pumps LED light). The following data is displayed here:
-
Current error
-
Last error (the last detected error)