beautypg.com

AVSL 600.100 MTM01 User Manual

Page 11

background image

MTM01 User Manual

4. The meter will show the approximate forward voltage

of the diode. If the connections are reversed, “1” will be

shown on the display.

TRANSISTOR hFE MEASUREMENT

1. Set the range switch to hFE range.
2. Connect the adapter to the “COM” jack and the “hFE” jack.

Don’t reverse the connection.

3. Identify whether the transistor is NPN or PNP type and locate

Emitter, Base and Collector lead. Insert the leads of the
transistor to be tested into the proper holes of the transistor

test socket of the adaptor.

4. LCD display will show the approximate hFE value.


BATTERY AND FUSE REPLACEMENT


1) Battery and fuse replacement should only be done after the test

leads have been disconnected and power is off.

2) Loosen screws with suitable screwdriver and remove case

bottom.

3) The meter is powered by a single 9V PP3 battery. Snap the

battery connector leads to the terminals of a new battery and

reinsert the battery into the case top. Dress the battery leads so
that they will not be pinched between the case bottom and case

top.

4) The meter is protected by fuse:

A) mA: F0.5A/600V Fast, Breaking capacity is 10KA,
dimensions are 20 x 5mmØ .

B) 10A: F10A/600V Fast, Breaking capacity is 10KA,
dimensions are 20 x 5mmШ .