AVSL 170.880 CLP1200 - Manual (Page 6)

170.880UK User Manual
Stereo Line EQ Section
15. HIGH EQ This control can boost or cut the high frequencies (centre 12kHz)
by ±15dB (12 o’clock position is zero)
16. HIGH-MID This control can boost or cut the high-mid frequencies (2.5kHz)
by ±15dB (12 o’clock position is zero)
17. LOW-MID This control can boost or cut the low-mid frequencies (250Hz)
±15dB (12 o’clock position is zero)
18. LOW This control can boost or cut the low frequencies (centre 80Hz)
by ±15dB (12 o’clock position is zero)
Channel Routing
19. FX POST This control governs the amount of signal from the channel routed
to the DSP effects engine. If a jack is connected to the FX SEND
connector (see 37 below), this will operate as an extra AUX output
(POST means post-fader - i.e. the signal routed to FX SEND
is also affected by the channel fader level)
20. AUX POST This control governs the amount of signal from the channel routed
to the AUX SEND or auxiliary output to external equipment.
(POST means post-fader - i.e. the signal routed to FX SEND
is also affected by the channel fader level)
21. POST / PRE Pressing this button in changes MON 1 and MON 2 outputs from
POST to PRE.
POST is post-fader, meaning the signals to MON 1 and MON 2
are also affected by the channel fader level.
PRE is pre-fader, meaning the signals to MON 1 and MON 2
are not affected by the channel fader level.
22. MON 1 This control governs the level of signal routed to the MON 1 OUT XLR connector.
The output can be used for monitoring or recording equipment.
23. MON 2 This control governs the level of signal routed to the MON 2 OUT XLR connector.
The output can be used for monitoring or recording equipment.
24. PAN/BAL This control adjusts the amount of signal from the channel fed to Left or Right outputs.
This varies the point in the stereo field that the signal appears. For ST1 and ST2
channels, the PAN control is replaced with a BAL control for Left/Right balance.