Aqua-Pure ASB1001 - Manual (Page 7)

1-3
Facts to Remember While Planning Your Installation:
1) All installation procedures MUST conform to local and state plumbing codes.
2) If lawn sprinkling, a swimming pool, or geothermal heating/cooling or water for other devices/activities are to be treated by the arsenic reduction
system, a larger model MUST be selected to accommodate the higher fl ow rate plus the backwashing requirements of the arsenic reduction
system. Consult your Dealer/Installer or our Customer Service Department at 1-800-222-7880 for alternative instructions if the pumping rate is
insuffi cient.
3) Remember that the arsenic reduction system INLET is attached to the pipe that supplies water (i.e. runs to the pump) and the OUTLET is the
line that runs toward the water heater.
CAUTION
To reduce the risk associated with property damage due to plugged water lines:
• Pay particular attention to correct orientation of control valve. Water fl ow should match arrow on control valve. The Inlet and Outlet of other water treatment
equipment products will vary depending on the control valve brand used.
4) Before commencing the installation it is advisable to study the existing piping system and to determine the size, number and type of fi ttings
required.
WARNING
To reduce the risk associated with a hazardous voltage:
• If the home electrical system requires use of the cold water system as an electrical safety ground, a jumper must be used to ensure a suffi cient ground connection
across the fi lter installation piping — refer installation to qualifi ed personnel.
5) Sweep the fl oor to eliminate objects that could pierce the media tank.