ADATA CE700 - Manual (Page 4)

ADATA Wireless Charging Stand FAQ
4
aligned, and the type of power supplying the CE700. Roughly, charging time is
about 1.3 times that of a wired charger.
6. Why can’t my phone be charged by the CE700?
Make sure the phone is compatible with the Qi wireless charging specification,
and check that the CE700 LED is on. If it is off, that means that CE700 is not
receiving power. Check the power supply. If the LED indicator is constant red or
flashing red, check the area between the CE700 and the phone for foreign
object. If there are no foreign objects found, pick up the phone and realign the
Rx / Tx zones.
7. Can a phone still be wirelessly charged by the CE700 if it is in a cellphone case
(cover)?
The CE700 uses the QI short distance specification. Under normal circumstances,
cell phones with outer covers will still work with wireless charging, but there
may be poor charging efficiency. If the case/cover is too thick, or contains metal,
then it will not be able to charge.
8. Can I use my own microUSB cable?
For optimum charging efficiency, use the supplied microUSB cable with the
CE700.Other compatible microUSB cables can also be used, but will likely result
in reduced charging efficiency. Cables longer than one meter may also reduce
the charging efficiency.
9. What specification AC adapter can I use with the CE700?
It is recommended to use a 5V 1.5A or higher AC adapter. Adapters lower than
this specification will likely result in lower CE700 charging efficiency.
10. CE700 LED indicators
CE700 LED Light Display
Status Standby Charging
Charging
complete
Charge
failure
Low
charging
level
Foreign
object
detection