Duro-Last 4" Flex Fascia Cover - Manual

DATA SHEET
4” Flex Fascia Cover
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The 4” Flex Fascia Cover easily snaps onto the Duro-
Last ® vinyl 4” fascia bar. Pre-notched grooves every 3”
allow fascia cover to easily snap over radial surfaces.
Fabricated in 10’ lengths; 4” width.
Can be installed on both inside and outside
radius edges.
Manufactured from various metals (see chart
below).
Contact Duro-Last or EXCEPTIONAL ® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED
®
and ENERGY STAR
®
compliant; Recyclable.
Installation:
1. Attach to a wood nailer.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawings #3510 and #3511.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .040 Mill or Kynar ®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar
®
Copper 16 oz. Mill