Operation, Gain adjustment, Locking and unlocking the controls – Shure GLXD4 Wireless Receiver User Manual

Page 13: Manually selecting a group and channel, Locking the receiver controls, Selecting a group, Selecting a channel, Locking the transmitter power switch, Glxd2 on

i i

i i i i i

Gain Adjustment

Operation

Locking and Unlocking the Controls

Locking the Receiver Controls

Simultaneously press and hold the group and channel

buttons until LK appears on the LCD. Repeat to unlock.

• LK is displayed if a locked control is pressed
• UN is displayed momentarily to confirm the unlock

command

Identifying Linked Transmitters and Receivers with Remote ID

Use the Remote ID feature to identify linked transmitter and receiver pairs in multiple receiver systems. When Remote ID is active, the receiver LCD will

blink and display ID. The status LED of the corresponding transmitter will alternately flash red and green for approximately 45 seconds.

Manually Selecting a Group and Channel

Specific groups and channels can be assigned to the receiver instead of using the automatic scan function.

Note: Group 3 should only be used in controlled Wi-Fi environments to prevent interference from unexpected Wi-Fi devices.

Selecting a Group

1. Press and hold the group button for 2 seconds until the group display

flashes.

2. Press the group button to scroll through the available groups.
3. The receiver will automatically save the selected group.

Selecting a Channel

1. Press and hold the channel button for 2 seconds until the channel

display flashes.

2. Press the channel button to scroll through the available channels.
3. The receiver will automatically save the selected channel.

Note: A double dash symbol

displayed on the receiver screen during a channel

scan indicates that there are no available channels within the selected group.

Choose a group with more channels and repeat set up steps.

The controls of the receiver and transmitter can be locked to prevent accidental or unauthorized changes to settings.

Note: Locks are not affected by power cycles.

Use the gain buttons on the receiver to increase or decrease the gain of a

linked transmitter:

• Turn on the linked transmitter and momentarily press the gain

buttons to adjust the gain in 1 dB increments

• For faster gain adjustments, press and hold the gain buttons

Tip: Monitor the audio and observe the receiver audio meter level while adjusting the

gain to prevent signal overload.

To activate Remote ID:
1. Momentarily press the link button on the transmitter or receiver.
2. The LCD of the linked receiver will blink and display ID and the status

LED on the linked transmitter will flash red/green.

3. To exit Remote ID mode, momentarily press the link button or allow the

function to timeout.

Locking the Transmitter Power Switch

Starting with the transmitter set to off, press and hold the LINK button while

turning on the transmitter. Continue to hold the link button until the lock icon

appears on the receiver LCD. Repeat sequence to unlock.
Optionally, the transmitter power switch can be remotely locked from the receiver front

panel:
Simultaneously press and hold the group and link buttons for approximately 2 seconds

until the flashing lock icon appears on the receiver LCD. Repeat sequence to unlock.

rf group

link channel

gain

III

II I

I I

GLXD4

group

channel

gain

link

I I I I

I I

I I I

GLXD2

I I I I

I I

I I I I

I I