Troubleshooting – Yamaha CD-S2000 User Manual
Page 21
21
En
Troubleshooting
Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or
if the instructions below do not help, turn off this unit, disconnect the AC power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
Cause
Remedy
See
page
The unit does not
switch ON when
POWER is pressed
upward.
The power cord is not connected nor completely
connected.
Securely connect the power cord.
The disc tray does not
close completely.
A foreign object is obstructing the tray.
Carefully check the disc tray and remove the
foreign object.
—
Playback does not
start.
The disc is damaged.
Check the disc carefully; replace it if necessary.
—
There is moisture on the laser pickup.
Wait 20 to 30 minutes after switching the unit
ON before trying to play back a disc.
—
The disc is loaded upside down.
Reload the disc with the label side up.
—
The disc is dirty.
Clean the disc.
—
The MP3 or WMA formats are not compatible
with this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
The CD-RW (ReWritable) disc is not recorded
correctly.
Replace the disc with a correctly recorded disc
playable with this unit.
—
The disc is a non-standard disc not playable with
this unit.
Replace the disc with a correctly recorded disc
playable with this unit.
—
Playback is delayed,
or begins at the
wrong place.
The disc may be scratched or damaged.
Check the disc carefully; replace it if necessary.
—
No sound.
Improper output cable connections.
Connect the cables properly. If the problem
persists, the cables may be defective.
Improper amplifier operation.
Set the amplifier controls to the correct input
selection.
—
Sound “skips”.
This unit is being subjected to vibrations or
impacts.
Relocate this unit.
—
The disc is dirty.
Clean the disc.
—
Sound “hums”.
Improper cable connections.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Noise from a nearby
tuner.
The tuner is too close to this unit.
Move the tuner and this unit farther apart.
—
Noise from inside of
the disc tray.
The disc may be warped.
Replace the disc.
—
The remote control
does not work.
The batteries of the remote control are too weak.
Replace the batteries with new ones.
Remote control is too far away or tilted too
much.
Use within 6 m and 60° radius.
Direct sunlight or lighting (of an inverter type
fluorescent lamp etc.) is striking the remote
control sensor of this unit.
Reposition this unit.
Eng
lish