Installing the yamaha crw4416sx drive, Crw4416sx drive settings, Cdr id – Yamaha CRW4416SX User Manual

Page 15

Chapter 3 - Installing the Yamaha CRW4416SX Drive

CRW4416SX drive settings

■

SCSI ID settings

The SCSI ID number is used so that the computer will recognize a con-

nected SCSI device. You can assign 0 through 7 as the SCSI ID num-

ber. Usually, “7” is reserved for the SCSI card ID number, and “0” is

reserved for the first SCSI device in the chain. Use a number between 1

and 6 for the CRW4416SX.

Use the switch on the rear panel to set a SCSI ID number. The factory

set ID number is “1”.

Caution: If you are using other SCSI devices, be sure to use a unique ID number

for each device. Be sure to turn off the power to the drive before you set

the SCSI ID number.

Note: When you are using Windows 95 or Windows 98, and if the SCSI ID

setting on the rear panel is the same as the number assigned to another

SCSI device, the Plug and Play component of Windows 95 or Windows

98 will automatically assign an unused number to the CRW4416SX

(SCAM protocol level 1).

CDR ID

–

Pressing this switch repeatedly
will decrease the SCSI ID
number by one each time.

Pressing this switch repeatedly
will increase the SCSI ID
number by one each time.

SCSI ID Number