Yamaha DPX-1300 - Manual (Page 21)

17
Projection
8
English
Checking installation and connections
◆ Pre-operation check
Prior to projection, adjust settings to suit the location of the main unit and screen, and the input signal you are using.
However, there is usually no need to adjust any settings if you have not changed the installation location or components since the last time
you used this unit. Check settings and connections only when the unit does not appear to project images correctly.
PHONO DVR STANDBY /ON
PURE DIRECT
2CH/MULTI CH SPEAKERS
VIDEO AUX
REC OUT/ZONE 2
INPUT MODE SOURCE/REMOTE DVD DTV/LD MD/TAPE CD-R TUNER CD
VIDEO AUX VCR 2 VCR 1 SAT CABLE A B STRAIGHT EFFECT
MULTI CH INPUT DSP PROGRAM BALANCE
TONE CONTROL
VOLUME
INPUT SELECTOR
MULTI JOG
SILENT OPTIMIZER MIC
PHONES OPTICAL R AUDIO L VIDEO S VIDEO
Is the main unit power
turned on? Main unit
Are the components connected correctly?
“Connecting to AV components”
☞ page 15 - 16
Image source component
Is the source component power
turned on?
For an explanation of detailed settings, see “Menu”. ☞ page 27 - 47
Check installation and connections
Select an image for projection and image adjustment
Projection preparations complete
Turn on the projector power.
Begin playback of the source image for adjustment.
Select a projection image.
(Select an input signal and projection image aspect.)
Adjust focus and vertical/ horizontal positioning.
8 Projection
Prior to projection, check that the main unit and screen are correctly installed, and that source components are connected correctly.
To project images, carry out the following procedure.
Is the screen installed correctly?
“Setting up the DPX-1300”
☞ page 12
12_DPX-1300_E.p65 9/20/05, 4:00 PM 17