Yamaha DVD-C940 - Manual (Page 14)

10
Inserting batteries into the
Remote Control
1 Open the battery cover.
2 Insert batteries (AA size) with the correct polarity
as indicated by the +
and - symbols inside the
battery compartment.
3 Close the cover.
CAUTION!
– Remove batteries if they are exhausted or
not to be used for a long time.
– Do not use old and new or different types
of batteries in combination.
– Batteries contain chemical substances, so
they should be disposed off properly and
kept away from children.
Using the Remote Control
● Direct the remote control at the remote sensor
of the player.
● Do not drop the remote control.
● Do not leave the remote control near extremely
hot or humid places.
● Do not spill water or put anything wet on the
remote control.
NTSC/PAL Conversion
DVD discs are recorded according to color
system eg. NTSC and PAL. Your TV also operates
according to a color system.
This DVD player is compatible with NTSC and
PAL. To play on this DVD player, the color
system of the DVD disc, the TV and the DVD
player should match. If all three are not the same,
the DVD may play in only black and white, the
picture may roll continuously or the picture may
appear distorted.
To activate the conversion, refer to page 13.
Switching On
1 Connect the AC power cord to the power outlet.
2 Switch on the TV and DVD player.
3 Select the correct input channel at your TV and
set the input source at your AV receiver to DVD.
➜ The player display lights up and the default
screen appears on the TV.
4 If you are using an external equipment (eg. audio
system or receiver), turn them on and select the
appropriate input source that was used to
connect to the player output. Refer to the
equipment owner’s manual for detail.
Note:
– If you do not have a proper picture or sound, refer
to ‘Troubleshooting’ section.
+
-
+
-
Preparation