Yamaha wr450f - Manual (Page 12)

12
Assembling
16
Apply a thin layer of Öhlins red grease (146-01)
on the scraper ring and on the sealing surface of
the fork seal.
CAUTION!
When installing the oil seal and bushing use a small
plastic bag to cover the bushing attachment
groove and edges of the inner tube, to avoid
damage to the seals.
Mount the scraper, circlip, fork seal, support ring
and the bushing separated by the sleeve on the
inner steel leg.
18
Apply some Öhlins red grease on the seals.
Again, use tool (1799-04), flip it around to install
the seal in the outer leg.
Install the circlip and the scraper.
CAUTION!
Make sure the circlip is fitted correctly into the
groove in the outer leg.
17
Fasten the outer leg in a vice with soft jaws.
Install the inner leg and mount the sleeve and
the lower bushing. Use tool (1799-04).
Sleeve
Bushing
Tool 1799-04
Circlip
Scraper
Outer leg
Seal
Inner leg
Tool 1799-04
Inner leg
Scraper
Circlip
Seal
Washer
Bushing
Sleeve
Bushing