Xilinx MIcroblaze Development Spartan-3E 1600E - Manual (Page 72)

70 MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide
www.xilinx.com UG257 (v1.1) December 5, 2007
Chapter 9: Digital to Analog Converter (DAC) R
Interface Signals
Table 9-1 lists the interface signals between the FPGA and the DAC. The SPI_MOSI,
SPI_MISO, and SPI_SCK signals are shared with other devices on the SPI bus. The
DAC_CS signal is the active-Low slave select input to the DAC. The DAC_CLR signal is
the active-Low, asynchronous reset input to the DAC.
The serial data output from the DAC is primarily used to cascade multiple DACs. This
signal can be ignored in most applications although it does demonstrate full-duplex
communication over the SPI bus.
Disable Other Devices on the SPI Bus to Avoid Contention
The SPI bus signals are shared by other devices on the board. It is vital that other devices
are disabled when the FPGA communicates with the DAC to avoid bus contention.
Table 9-2 provides the signals and logic values required to disable the other devices.
Figure 9-2: Digital-to-Analog Connection Schematics
Header J5
DAC A
12
DAC B
12
DAC C
12
12
SPI_MOSI
DAC_CS
SPI_SCK
DAC_CLR
CS/LD
SDI
SCK
CLR
SDO
SPI_MISO
(N10) (T4)
(U16)
(P8)
(N8)
3.3V
2.5V
A
B
C
D
GND
VCC
REF A
REF B
REF C
REF D
VOUTA
VOUTB
VOUTC
VOUTD
Spartan-3E FPGA
DAC D
LTC 2624 DAC
SPI Control Interface (3.3V)
UG257_09_02_060606
Table 9-1: DAC Interface Signals
Signal FPGA Pin Direction Description
SPI_MOSI T4 FPGAÆDAC Serial data: Master Output, Slave Input
DAC_CS N8 FPGAÆDAC Active-Low chip-select. Digital-to-analog
conversion starts when signal returns High.
SPI_SCK U16 FPGAÆDAC Clock
DAC_CLR P8 FPGAÆDAC Asynchronous, active-Low reset input
SPI_MISO N10 FPGAÅDAC Serial data: Master Input, Slave Output