Yamaha BLASTER YFS200N - Manual (Page 105)

EBU00597
Transmission oil
1. Transmission oil measurement
a. Place the machine on a level place.
b. Warm up the engine for several minutes,
and stop it.
c. Check the oil level through the level win-
dow located at the right side crankcase
cover.
NOTE:
Wait a few minutes until the oil level settles
before checking.
d. The oil level should be between the maxi-
mum and minimum marks. If the level is
low, add oil to raise it to the proper level.
2. Transmission oil replacement
a. Place the machine on a level place.
b. Warm up the engine for several minutes,
and stop it.
c. Place a container under the engine.
d. Remove filler cap and drain bolt to drain
the oil.
e. Install the drain bolt and tighten to specifi-
cation.
f. Fill the engine with oil and install the filler
cap.
1. Level window 2. Maximum level mark
3. Minimum level mark
8-5
q
q
w
e
Tightening torque
Drain bolt:
20 Nm (2.0 m•kg, 14 ft•lb)