Yamaha EMX100RDS - Manual (Page 33)

E-25
English
Automatic preset tuning
You can also make use of an automatic preset tuning
function. By this function, this unit performs automatic tuning
and stores stations with strong signals sequentially. Up to 40
stations are stored automatically in the same way as in the
manual preset tuning method on the previous page.
1
Select the tuner by turning the INPUT SELECTOR until
“TUNER” appears on the display.
2
Press and hold the tuner MEMORY button for more than
2 seconds.
* The MEMORY and AUTO indicators will flash.
This unit performs automatic tuning and searches FM and
AM (MW and LW for U.K. and Europe models only) stations
in that order. Received stations are programmed to A1, A2 ...
A8 sequentially.
When the automatic preset tuning is completed
The display shows the frequencies of the first preset station
(stored to A1).
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on the previous page.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on the previous page.
Notes
• The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM
stations only.
•
The unit is originally set so that only RDS stations are
searched instead of all FM stations by this operation. (FM
stations that employ no RDS network service cannot be
programmed.)
However, you can change the setting so that the unit can
program not only RDS stations but also other FM stations.
(Refer to page 29 for details.)
• With this function, only stations with sufficient signal
strength are stored automatically. If the station you want
to program is weak in signal strength, tune to it in
monaural manually and program it by following the
procedure of the section “To store stations” on the
previous page.
• You can replace a preset station with another FM or AM
(MW or LW) station manually by simply following the
procedure of the section “To store stations” on the
previous page.
CD CHANGER RECEIVER EMX–100RDS
PHONES
DISC 1 2 3
PROGRAM
MUSIC
USER MEMORY
INPUT SELECTOR VCR/LD-TV/CD/TUNER/TAPE•MD/AUX VOLUME
RANDOM
DISPLAY MIC
MIN MAX
MIC MIXING
REPEAT TIME MEMORY AUTO/MAN'L
HOUR PRESET/TUNING/BAND A/B/C/D/E MIN TIME ADJ TIMER
OPEN/
CLOSE
DISC
CHANGE
STANDBY/ON
MODE PTY SEEK START FREQ PS/PTY/RT/CT
PTY SELECT PTY SELECT
TUNING OPERATION
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B C D
+ I0
E
OPEN/CLOSE RANDOM REPEAT MODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
STOP
INPUT
PLAY/PAUSE
LEVEL MUSIC
TEST FLAT CENTER/REAR
/DELAY
PROGRAM USER
STANDBY/ON
DISPLAY SLEEP
VOLUME
2 1
1
Memory back-up
The memory back-up circuit prevents the programmed
data from being lost even if the AC supply lead is
disconnected from the AC outlet or the power is cut due
to temporary power failure. If, however, the power is cut
for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the
preset tuning steps.